Hoping someone
can help me, been struggling for a few days.
Trying to
establish a Gateway to Gateway VPN Tunnel with the below hardware
Linksys WAG300g
Bridged to Cisco RV082 - HQ
Huawei HG655B
Home Gateway Bridged to Cisco RV082 - Branch
HQ
Local Group
Setup:
Local Security
Gateway Type: IP Only
IP Address:
xxx.xxx.xx.xx (WAN IP) - Can ping from remote pc.
Local Security
Type: IP (For testing)
IP Address:
xxx.xx.1.200
Remote Group
setup:
Remote Security
Gateway Type: IP Only
IP Address:
xxx.xxx.xx.xx (WAN IP) - Can ping from remote pc.
Remote Security
Type: IP (For testing)
IP Address:
xxx.xx.2.101
IPSec Setup: All
Default
Keying Mode: IKE
With Pre Shared Key
Phase 1 DH Group:
Group 1 - 768 bit
Phase 1
Encryption: DES
Phase 1
Authentication: MD5
Phase 1 SA Life
Time: 28800 seconds
Perfect Forward
secrecy: Checked
Phase 2 DH Group:
Group 1 - 768 bit
Phase 2
Encryption: DES
Phase 2
Authentication: MD5
Phase 2 SA Life
Time: 3600 seconds
Preshared Key:
xxx
Min Preshared Key
Complexity: Checked | Enabled
Aggressive Mode:
Checked
NetBIOS
Broadcast: Checked and Enabled on NIC
Dead Peer
Detection: Checked
Branch is set
exactly the same though obviously Local and Remote Groups info switched.
No Antivirus or
firewalls enabled on either pc to test. Disabled Firewall on RV082's as well to
eliminate any potential issues.
I can get a VPN
connection, but cannot ping the LAN IP of the RV082 on either side.
Cannot access any
local resources on either end either.
What am I missing
here? Both Pc's are Win 7 Pro 64bit if
that makes any difference at all. Both RV02's have Public Ip's which I can
ping.
The solution:
You would try
changing from Local Security Type: IP to subnet and also uncheck aggressive
mode.
Customers interested in purchasing Cisco switch or the price, please refer to below links, here are some popular switch for you:
没有评论:
发表评论